Omega-engineering OMEGASCOPE OS533 User Manual download pdf (Page 39)

Using the Handheld Infrared Thermometer

2-24

2.3.11 Storing the Temperature Data on Command

(OS534, OS523, OS524)

The thermometer can store up to 100 temperature data

points on command. Each set of temperature data is broken

down into the temperature value, emissivity, and high

alarm setpoint for that temperature. This data is stored in

non-volatile memory, so removing the batteries will not

affect this data. To store temperature data:

1. Aim at the target and pull the trigger and press the

key to lock the trigger. The icon will appear

on the display.

2. If necessary, press the key to increment the target

emissivity or press the key to decrement the target

emissivity.

3. Press and hold the key until the Memory Display

Mode (MEM) appears.

4. Press the key to increment the memory location or

press the key to decrement the memory location.

The memory location can be from 001 to 100.

5. Press the key to store the target temperature at the

memory location indicated. You will hear a beep to

verify that the data is stored.

You can write over any previously stored

memory locations.

6. After all data is taken, press and hold the key

until the Emissivity Display Mode (E) appears.

7. Press the key to unlock the trigger.

NOTE

°F

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 77 78

No comments

Omega-engineering OMEGASCOPE OS533 User Manual Page 39