Omega-engineering CN9400 User Manual download pdf (Page 14)

If this cycle-time is suitable press and hold both ▲ and ▼

buttons for 3 seconds to enter it into the controllers

memory.

If the calculated cycle-time is not compatible with the

switching device press and hold the ✱ button then press

and hold ▲ or ▼ until a more suitable cycle-time is

displayed. Release the buttons, then press and hold both

▲ and ▼ buttons for 3 seconds to enter it into the controllers

memory.

Pre-Select Automatic Acceptance of Any Autotune

Cycle-time

Before selecting Autotune, enter program mode.

Select CYC.T

Press and hold the ✱ button then press and hold ▼

until indexing stops and

A- -

is displayed in the

lower display

Note:

A- -

indicates that no cycle-time exists.

Press and hold ▼ to scroll to

tunE

The controller will now display

Press and hold the ✱ button and use ▲ to select

either

At.SP

. Release ▲.

The controller will now run Autotune and will accept the

calculated cycle-time.

To Pre-Select Cycle-time Before Autotune

Before selecting Autotune, enter program mode.

Select

Press and hold the ✱ button, then press ▲ to increase

or ▼ to decrease the displayed cycle-time. Release

buttons when required value is displayed.

Select

or index to another function then exit program mode.

Proportional cycle-time

ON.OF

0.1

A --

Factory setting

ON/OFF

Autotune calculated

cycle-time

Manual settings

Seconds

✱ ▼

✱ ▲

Proportional Cycle-time (continued)

CYC.T

A--

TUNE

OFF

CYC.T

TUNE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Comments to this Manuals

No comments

Omega-engineering CN9400 User Manual Page 14

Comments to this Manuals

Related products and manuals for Thermometers Omega-engineering CN9400