Omega-engineering CN9400 User Manual download pdf (Page 21)

Function List

Function Options

[Factory settings] shown in brackets

A - - on.oF 0.1 - 81 sec [20]

SP1 proportional cycle-time (see pages 9/10)

Determines the cycle rate of the output device for

proportional control. Select

on.oF

for ON/OFF mode.

[0] to * °C/°F

SP1 offset/manual reset

* ±50%

bAnd

. Applicable in proportional and ON/OFF

mode with integral disable:

Int.t oFF

[oFF] on

Lock main setpoint

Locks the setpoint preventing unauthorised

adjustment.

PROGRAMMER SETTINGS (see page 11)

[0] to 9995 deg/hour

Sets the ramp rate

on [oFF] hoLd

Switches the ramp on or off, or hold at last ramp value

[oFF] 0 to 1440 min

Sets the soak time

SP2 OPERATING PARAMETERS (see pages 12/13)

Function Options

[Factory settings] shown in brackets

0 to * °C/°F [0]

Adjust SP2 setpoint

* Deviation Alarms

DV.hi, DV.Lo, bAnd

25% sensor maximum (see figure 7).

* Full scale alarms

FS.hi, FS.Lo

sensor range f/s (see figure 8)

0.1 - * °C/°F [2.0 °C/3.6°F]

Adjust SP2 hysteresis or proportional band/gain

(see

CyC.2

setting)

* 25% sensor f/s

[on.oFF] 0.1–81 seconds

Select SP2 ON/OFF or proportional cycle-time

Select on.oFF for ON/OFF mode, or the cycle rate of

SP2 output device for proportional mode.

LEVEL 1 (continued)

CYC.T

OFST

SP>LK

SPRR

SPRN

SOAK

SET.2

BND.2

CYC.2

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 37 38

Comments to this Manuals

No comments

Omega-engineering CN9400 User Manual Page 21

Comments to this Manuals

Related products and manuals for Thermometers Omega-engineering CN9400